FAQs
We are here to answer your common questions about Wagner products. Browse below for frequently asked questions and always reach out to us if you don’t see the answer you are looking for.
Where can I get parts for my Power Painter/Stainer?
Parts can be purchase through online distributors, Wagner Online or by calling us direct at 1-800-328-8251.
Read MoreCan the Power Painters/Stainer be used with 220volt?
These sprayers cannot be used with 220volt, it is rated for 110volt only. If you need a 220volt sprayer you can find a dealer or see our 220volt Wagner version.
Read MoreHow should I clean my Power Painters/Stainer?
Use the appropriate cleaning solution (warm, soapy water for latex materials; mineral spirits for oil-based materials). Always check the back of the paint container for appropriate cleaning solution.
Read MoreCan I use Power Painters/Stainer with 5 gallon bucket?
The EZ-Tilt Power Painters/Stainer will work with the 5 gallon bucket of paint with the remote suction set assembly which may need to be purchased separately.
Read MoreWhat is the PSI (Pound per square inch) and tip size for the EZ-Tilt Power Painters?
The pressure is about 2,000-2,500PSI. The sprayer has dual orifice technology.
Read MoreDo I need to thin the material?
Thinning the material may not be necessary if it has been properly mixed, strained through a paint strainer, and you have the correct tip size.
Read MoreCan the Power Painter/Stainer be used indoors?
The Power Painters/Stainer is not recommended for spraying indoors.
Read MoreWhat is the warranty on the Control Series?
This Product, Manufactured by Wagner Spray Tech Corporation, is warranted to the original retail purchaser against defects in material and workmanship for one year from the date of purchase if operated in accordance with Wagner’s printed...
Read MoreWhere can I get parts for my Control Series?
Parts can be purchased through online distributors, Wagner Online at www.wagnerspraytech.com or by calling us directly at 1-800-328-8251.
Read MoreWhat should I use to clean my sprayer?
Warm, soapy water for water-based materials; mineral spirits for oil-based materials, along with a soft bristle brush and a rag. Always flush with clean water after the mineral spirits. Always check the back of the paint...
Read MoreCan I spray oil base products?
The Control series will spray both water and oil-based coatings. Do not spray or clean with liquids having a flash point of less than 100ºF (38ºC). Flash point is the temperature at which a fluid can...
Read MoreCan I spray paint with the Control Series?
Some Control Spray units are able to spray some thinned latex paints. They are: Paint & Primer in One and primer are not recommended to be used in the Control Series.
Read More